took pics of it. thread will be up int eh next 24hrs

thats how i've always done it in the past, i dont like what it does to the floor

x2 it was tight

Ordered stuff from honda
roof moldings and clips
rear quarter trim
Trunk and gas latches
rear trim panels above the tails
Windshield moldings
and other misc shit

I have a feeling your CRX is going to take top honors in AZ.:nutswinger:

installed my front feder liner. HOnda says 14 will work for both front fenders well i came up a clip short. i only picked up one pack of clips so i had to run to honda and get another clip. also found out honda doesent carry the screws that hold the mudflaps. ALso I managed to install 1 mudflap today.

:bigok:put on 0 offset 15x8 wheels and slammed it

got it back today from tritech...now i can get back to buying stuff

just fish bowled half my car.

Always a good choice, did it to the rex in stages and I couldn't be happier. That is until I take it out of the garage.

lol for serious, especially in az... i'm gonna do it to mine since my tint is just peeling off.

wishin i had some wheel bearings for my DA.. sucks not driving it.. its being almost a month.. SHIT!!!

took some pics thx to reaper and they will be up soon.

Finished installing my other Mudflap. both front mudflaps are on.

drove around town to order parts. the motor goes in tomorrow plus the tuck should be done at the same time!!! kinda excited

all i did to the car was puch it back and clean the car port to get ready for the swap

Reassembled my interior and got some small stuff touched up.

I put my frontend on my car to see how it looks and alittle photo session.

^^^ It looks FAST! but is it FAST! lol!

She's getting there. It's a standard model that's has had the Si spindles an Si interior swaped. No moon roof no rear disc brakes and sound padding. It's light as fuck. The other hatch has a built b20.

i just keep looking at it..
undecided if i want to hold on to it until spare cash comes to buy a swap or part it out:(
FUCK!

found out that the engine harness that came with the shell is a si harness and the cabin harness is a dx harness. moarrrr wiring now. putting the motor in in a little

LOL! not lighter than mine I bet you, looks good do.

looking good danzi, it's nice to finally see my old front end getting some use ;)

Started wire tuck.......fuck its aot of wires.........does anyone have an idea on how to redirect the brake lines and fuel lines as well?

Yea thx for the frontend brother. You should roll by I got my hatch running now.

Cars with no motors are pretty light you got me there.

for sure man! give me a call sometime next week and we can set something up


buy a flaring tool, tubing bender and a lot of bulk tubing and go to town.

Finally finishing my hydro pedal conversion so i can finally drive it with the type r tranny.

New rubber
 

i sold it hahaha