Thanks buddy. I know I plan on it being anywhere from 4-8 grand build so I'm willing to spend that just wanna make sure it's all right and is reliable.

that's a lot of money to spend on such little power

I agree

There are so many ways to build this its not even funny just copy someone else's build on b20v.com finished.

Sent from my Nexus 4 using Tapatalk 2

That budget will get you a really nice built motor... If your serious and when you have the cash send me a PM and I can give you a bunch of contacts to call for the block work and head work down to all the parts you will need.

Best advice is to go all out, take your time and build a good race car that you can take out for cruises here and there but use it mainly for the track.

Buy a good DD and leave it stock, life is so much easier when you have a reliable car.

Your welcome.

The motor on my avatar made a little over 260 on race gas. Hope it keeps your hopes high... lol

Hey man I was cruising around on HT and saw this link... This should really give you an idea of what you could do.. This set up really shouldn't cost more then 3 to 4k

The guy made 240whp on a very basic setup with pump gas... for his daily driver..

I mean 11.5 compression on RS pistons, stock sleeves.. 82mm
stock rods and crank

I know this the typical thing for a k guy to say, but if you have the funds for it, is there any reason why you wouldn't do a k swap? A k20z3 with DC drop in cams, tb and nice header will see 245+ whp and drive like stock.

Gawd damn.. nice find

If I was going to run an all motor setup and was starting from scratch I would go with a K setup..

I was actually looking into stuff for a k swap but to put a k swap into a 91 teg is a lot of fabricating (which I'm not good with lol) but to have a k swap in a db1 would be sick and get a lot of attention.
I really appreciate all the help and opinions!!!
Thanks guys!

That is a simple build and some good power I'm just concerned that my car is heavier then most b20v cars and I wanna make sure I can put all that power to the ground and still see around 12 or under 12 would be awesome. I have been doing a lot of research on ht -and have found a lot of my answers already

Did a lot more research on k20 swap and I'm gonna do it.
I have found most of the swap parts already!!
Still gonna be expensive though!!

Good choice.

Your doing a k swap in a da?

A db1 to be exact haha

Looking to build a 8-9 k all motor build but your broke?

Am I the only one who caught this..

Brb guys gonna make a thread about what I wanna do to my TSX but have zero money for it.

gotta get ideas!

A build doesn't happen over night.
It is gonna take me probably 6-8 months to finish, and I'm fine with that.
Doing research and hearing what other people have to say is knowledge i can use In my build.

Plus if I was looking to buy I would be searching for sale threads not posting to get advise, thanks for yours though.